Ac / Power Precautions; Lamp Precautions - Christie D4K2560 User Manual

Introduction

AC / Power Precautions

To correctly install this projector, a certified electrician must install a permanent connection to the
projector head. Operate the projector at the recommended voltage.
Disconnect projector from AC before opening any enclosure. Failure to comply results in
death or serious injury.
Failure to comply with the following could result in death or serious injury:
• Verify that the projector is using a line cord, socket and power plug that meets the
• DO NOT allow anything to rest on the power cord. Locate the projector where the cord
• DO NOT overload power outlets and extension cords as this can result in fire or shock

Lamp Precautions

Lamps used in the projector are under high pressure and must be handled with caution. Lamps can
explode and cause serious personal injury if they are dropped or mishandled.
Failure to comply with the following results in death or serious injury:
• Never attempt to access the lamp compartment while the lamp is On. Wait at least 10
• The arc lamp operates at a high pressure that increases with temperature. Failure to allow
• Always wear manufacturer approved protective safety clothing (gloves, jacket, face
Failure to comply with the following could result in death or serious injury:
• Possibly hazardous optical radiation emitted from this product. (Risk group 3)
• Thermal radiation emitted from this product may cause burns. (Risk group 3)
Recommended protective clothing includes, but may not be limited to a polycarbonate face
shield, protective gloves, and a quilted ballistic nylon jacket or a welder's jacket. This
equipment is included in included in the Christie Protective Clothing Safety Kit
P/N: 598900-095.
Christie's protective clothing recommendations are subject to change. Any local or federal
specifications take precedence over Christie recommendations.
2
appropriate local rating standards. Use only an AC power cord recommended by Christie.
Do not attempt operation if the AC supply and cord are not within the specified voltage
and power range.
cannot be abused by persons walking on it or objects rolling over it. Never operate the
projector if the power cable appears damaged in any way.
hazards.
minutes after the lamp turns Off before powering down, disconnecting from AC and
opening the lamp door.
the lamp to sufficiently cool before handling, increases the potential for an explosion
causing personal injury or property damage.
shield) whenever the lamp door is open or when handling the lamp. Only qualified
technicians should install projector lamps.
D4K2560/Mirage 4K25 User Manual
020-101076-02 Rev. 1 (11-2013)