3D Synchronization Problems; Left And Right Eye Are Reversed - Christie D4K2560 User Manual

Troubleshooting

3D Synchronization Problems

A direct input 3D source requires a 3D external sync. The Status tab/Signal group has a 3D Sync item
that displays "Valid 3D sync" if the incoming sync is correct.
• If "No 3D sync (using internal sync)" is displayed, no sync signal is detected on the 3D Sync In
port.
• If "Invalid 3D sync (using internal sync)" is displayed, the sync signal is present but it is either
not locked or is out of phase with the vsync of the master signal.
In both cases, the sync from the 3D source must be verified.

Left and Right Eye are reversed

Provided the Confirming Emitter setup was successfully performed, the 3D source in combination
with the 3D external sync may be reversing the frames. To correct this, go to Main menu > Image
Settings > 3D Settings and select Invert Left/Right Eye.
54 D4K2560/Mirage 4K25 User Manual
020-101076-02 Rev. 1 (11-2013)