Christie D4K2560 User Manual page 22

Installation and Setup
3. Connect to the terminal block. NOTE: The terminal block
accommodates up to an 8 AWG wire. If desired, a 90° strain relief
connector can be used to route the power cable in a downward
direction.
Always connect the ground lead first to reduce shock hazard.
• If connecting to permanent power, connect the AC power
source to the terminal block, beginning with the ground lead.
• If connecting to a pluggable type-B cable, connect the cable
to the terminal block, beginning with the ground lead.
• Use an appropriately sized strain relief connector with the
knockout plate provided to ensure adequate environmental sealing and to prevent the
cables from wear and accidentally being torn out.
4. Reinstall the knockout plate and secure it with 4 screws.
5. Reinstall the bottom access panel over the terminal block and secure it with 2 screws.
6. If using a pluggable type-B cable, connect to the building's AC power source.
12
3
D4K2560/Mirage 4K25 User Manual
020-101076-02 Rev. 1 (11-2013)