Maintenance; Maintenance Shutdown - Christie D4K2560 User Manual

Maintenance

This section provides information and procedures for performing projector maintenance. Read
through this section in its entirety before performing maintenance activities. When performing
projector maintenance, obey all warnings and precautions.
Never attempt to access the lamp compartment while the lamp is on. Wait at least 10
minutes after the lamp turns OFF before powering down, disconnecting from AC and opening
the lamp door.
The arc lamp operates at a high pressure that increases with temperature. Failure to allow
the lamp to sufficiently cool before handling, increases the potential for an explosion causing
personal injury or property damage.
Always wear manufacturer approved protective safety clothing (gloves, jacket, face shield)
whenever the lamp door is open or when handling the lamp.
When accessing the restricted access location for projector service or maintenance, avoid
exposure to the projector beam path by making sure to either:
• Power OFF the projector and disconnect from AC.
• Shutter the lamp to avoid emissions from the front aperture.
Failure to comply could result in death or serious injury.
• Qualified technician required for all installations.
• Never operate the projector without all of it's covers in place.

Maintenance Shutdown

This process is mandatory. Always perform these steps before beginning any inspection or
maintenance procedures on the projector.
1. If the projector is operating, turn it off and allow it to cool for a minimum of 10 minutes.
2. Set the projector breaker switch to the OFF position.
3. Set the lamp power supply's 3 breaker switches to the OFF positions.
Disconnect the projector from AC power.
D4K2560/Mirage 4K25 User Manual
020-101076-02 Rev. 1 (11-2013)
43