First-Time Power-Up - Polycom 1500 Hardware Manual

RealPresence Collaboration Server (RMX) 1500 Hardware Guide
The LAN 1*, LAN 3, LAN 4 and Modem ports are not to be used and the plastic caps covering those
ports should not be removed.
* With Multiple networks and LAN redundancy configurations, LAN 1 port is used. For more
information, see RealPresence® Collaboration Server (RMX) 1500/1800/2000/4000 Administrator's
Guide, LAN Redundancy
When an NTP Server is used for the RMX time, the Shelf Management cable must be connected to
the shelf port.
● For the RTM ISDN 1500 module:
 Connect the E1/T1 cables to their PRI (1-4) ports.
Collaboration Server (RMX) 1500

First-time Power-up

Closely observe the following procedure when yopu switch on the Polycom RealPresence Collaboration
Server (RMX) 1500 for the first time.
To power up the RealPresence Collaboration Server (RMX) 1500 for the first time:
1 For first entry installation, you must insert the USB key containing the modified IP addresses in USB
slot on the RMX's front panel. For more information see, the RealPresence® Collaboration Server
1500/1800/2000/4000 Getting Started Guide,
2 Turn ON the power by pressing on the power switch located on the front panel of the Collaboration
Server (RMX) 1500.
Polycom, Inc.
and Multiple Network Services
Rear Panel View with AC Power and Communication Cables
First-time Power-up
.
.
22