Installation Using Surface Mount Bracket - Digital Watchdog x12 WDR PTZ User Manual

Installation -

Installation Using Surface Mount Bracket

Template Sheet
Drilling the Hole
1
on the Ceiling
Rubber Gasket
Fixing the Surface
2
Mount Bracket
2
Connecting the Cables and
3
the Terminal Block
Fixing the Main Body
4
Detaching the Protection
5
Film
11
Disassemble the main body with the surface mount
before installation the camera.
Drilling a Hole on the Ceiling
1
Using provided template sheet, drill a hole (30mm
diameter) on the ceiling panel to pass cables.
Fixing the Surface Mount Bracket
2
Pass the cables through the ¾" pipe hole, and screw
the surface mount bracket to the ceiling.
Rubber Gasket
- Before installing the gasket, the hole in the center is
to be cut by knife when only necessary.
Connecting the Cables and the Terminal Block
3
Connect the cables to the terminal block and then
put the terminal block in the slot of the main body.
(See the section 'Terminal Block' for details.)
Fixing the Main Body
4
Screw the main body to the surface mount bracket by
screwing 4 lock-up screws.
Detaching the Protection Film
5
Detach the protection film from the dome cover after
finishing all installation.