Digital Watchdog x12 WDR PTZ User Manual page 13

Installation -
Installation Using Wall Mount Bracket (Option)
Drilling a Hole on the
1
Wall and Fixing the
Anchor Bolts
Rubber Gasket
Fixing the Wall
2
Mount Bracket
Rubber Gasket
Fixing the Surface
3
Mount Bracket
Connecting the Cables
4
to the Terminal Block
Connecting the
5
Terminal Block
Fixing the Main Body
6
Detaching the
7
Protection Film
Disassemble the main body with the surface mount
before installation the camera.
1. Installing on the Concrete Wall
Drilling a Hole on the Wall and Fixing the Anchor
1
Bolts
To install the wall mount bracket, drill four holes
(6mm diameter/50mm depth) on the wall and insert
the anchor bolts into the hole.
Fixing the Wall Mount Bracket
2
1. Drill a hole (20mm diameter) on the pipe of the bracket
to pass the cables.
2. On the fixed anchor bolts, attach the rubber gasket
and screw the wall mount bracket.
2. Installing on the Wooden Wall
Drilling a Hole on the Wall
1
To pass cables to the wall, drill a hole (30mm
diameter) on the wall.
Fixing the Wall Mount Bracket
2
Pass the cables into the wall mount bracket, and
screw the wall mount bracket to the wall.
Fixing the Surface Mount Bracket
3
Pass the cables through the hole of the surface mount
bracket, screw the surface mount bracket to the wall
mount bracket.
Connecting the Cables to the Terminal Block
4
See the section 'Cabling the Terminal Block' for details.
Connecting the Terminal Block
5
Put the terminal block connected to the cables in the
slot of the main body.
Fixing the Main Body
6
Screw the main body to the surface mount bracket by
screwing 4 lock-up screws.
Detaching the Protection Film
7
Detach the protection film from the dome cover after
finishing all installation.
13