Table of Contents
Advertisement
2 Installation
2.1 Powering the Camera
Pass the wires through and make all necessary connections.
a single Ethernet cable, use the PoE Injector included with the
camera to connect data and power to the camera.
Power requirements
PoE IEEE 802.3bt PoE++ Class7 (PoE injector included)
2.2 Installation
1.
Install the mounting accessory (sold separately) to the mounting surface according to the installation
guide. A mounting accessory is required to install the camera properly. All mounting accessories are
sold separately.
2.
Pass wires through the mounting bracket.
3.
Connect the camera's base to the mounting accessory's neck using the bracket adapter. Secure the
camera to the adapter using the adapter screws included with the camera. Secure the camera to the
mounting bracket using the screws on the side of the mounting accessory neck.
4.
If you are using the wall mount bracket accessory, use the safety wire included with the camera to
secure the camera to the bracket's neck.
5.
Connect all wires to the camera.
6.
Remove the protection film and moisture silica gel when the installation is complete.
DWC-XPZA High-Speed PTZ IP Camera User Manual
Using
Power consumption
75W, 1.363A
2
Advertisement
Table of Contents
