First Time Booting Up - Digital Watchdog x12 WDR PTZ User Manual

Installation -
First-time Booting Up
Check Points before Operation
1. Before power is applied, please check the cables carefully.
2. The camera ID of the controller must be identical to that of the camera to be controlled. The camera ID can be check in the
system information of OSD menu.
3. If your controller supports multi-protocols, the protocol must be changed to match to that of the camera.
4. If you changed camera protocol by changing DIP switch, the change will be e ective after you reboot the camera.
5. Since the operation method can be di erent for each controller available, refer to the manual for your controller if camera
cannot be controlled properly.
Preset and Pattern Function Pre-check
Check how to operate preset, pattern, scan and group
function with keyboard controller/DVR in advance to operate
camera function using them.
(Refer to system keyboard manual)
Start OSD Menu
Using the OSD menu, preset, pattern, scan, group and alarm
input function can be configured for each application.
Enter 'Preset key + 95' .
Connect camera to power and make sure it is operating properly.
15. Camera will show Initializing Setup screen.
Note: Please record the information on this screen, especially the Protocol (If
set to Auto, it is probably Pelco-D), Baud Rate, and Camera's Address.
16. When initializing System is complete, screen will display camera's video.
Auto Calibration
If the camera is continuously subjected to very high temperatures (over 50°C or 122°F) for a long period,
the camera can lose focus and produce blurry images. In this case, it is recommended to turn on
AUTO CALIBRATION by running preset 165.
If you execute AUTO CALIBRATION, the camera will calibrate its focus for 10 seconds every 24 hours. To
turn OFF this function, please run preset 166.
17