Digital Watchdog x12 WDR PTZ User Manual page 14

Installation -
Installation Using Sunshield Mount
Disassemble the main body with the surface mount
and open the junction box cover before installation
the camera.
Drilling a Hole on the Wall and Fixing the Anchor
1
2 Fix the wall/ceiling Bolts
1
mount bracket
Drill a hole (6mm diameter/ 50mm depth) on the
wall, and fix the anchor bolts.
Fixing the Junction Box
2
On the fixed anchor bolts, attach and screw the
junction box.
Passing the Cables through the Wall Mount Bracket
3
Closing the Junction Box Cover
4
Close the cover to the junction box using the torx driver
provided before fix the sunshield mount.
Fixing the Sunshield Mount
5
Pass the cables through the pipe hole of the sunshield
mount, and fix the sunshield mount to the wall mount
bracket.
Connecting the Cables to the Terminal Blocks
6
Fix the Sunshield
2
- See the section 'Intallation - Cabling the 5P/7P
Mount
Terminal Block and the Audio Calbe' for details.
- Connect the cables to the terminal blocks and then
put the terminal blocks in the slots of the main body.
Connecting the other Cables
7
Connect the audio cable and crossover cable in the
connectors of the main body.
Connecting Wire the
3
Fixing the Main Body
8
Cables and Terminal
Screw the main body to thesunshield mount by
Blocks
screwing 4 lock-up screws.
Fixing the Main Body
4
Detaching the Protection Film
9
Detach the protection film from the dome cover after
finishing all installation.
Detaching the
5
Protection Film
14