Digital Watchdog x12 WDR PTZ User Manual page 15

Installation -
Installation Using Ceiling Mount Bracket and
Sunshield Dome (optional)
Rubber Gasket
Drilling a Hole on the
1
Ceiling and Fixing the
Anchor Bolts
1. Installing on the Concrete Ceiling
1
2
Fixing the Ceiling
2
Mount Bracket
2. Installing on the Wooden Ceiling
1
2
3
4
5
6
Fixing the Surface
3
Mount Bracket
7
Connecting the Cables
4
to the Terminal Block
Connecting the
5
Terminal Block
Fixing the Main Body
6
Detaching the
7
Protection Film
15
Disassemble the main body with the surface mount
before installation the camera.
Drilling a Hole on the Ceiling and Fixing the Anchor
Bolts
To install the ceiling mount bracket, drill four holes
(6mm diameter/50mm depth) on the ceiling and insert
the anchor bolts into the hole.
Fixing the Ceiling Mount Bracket
1. Drill a hole (20mm diameter) on the pipe of the bracket
to pass the cables.
2. On the fixed anchor bolts, attach the rubber gasket
and screw the ceiling mount bracket.
Drilling a Hole on the Ceiling
To pass cables to upside of ceiling, drill a hole (30mm
diameter) on the ceiling.
Fixing the Ceiling Mount Bracket
Pass the cables into the ceiling mount bracket, and
screw the ceiling mount bracket to the ceiling.
Fixing the Sunshiled Dome
Pass the cables through the hole of the Sunshiled Dome.
Screw the Sunshiled Dome to the ceiling mount bracket.
Connecting the Cables to the Terminal Block
See the section 'Cabling the Terminal Block' for details.
Connecting the Terminal Block
Put the terminal block connected to the cables in the
slot of the main body.
Fixing the Main Body
Screw the main body to the surface mount bracket by
screwing 4 lock-up screws.
Detaching the Protection Film
Detach the protection film from the dome cover after
finishing all installation.