Table of Contents
Advertisement
OSD -
MOTION SETUP & PARKING ACTION SETUP
1
MOTION SETUP
- - - - - - - - - - - - - - - - - - - - - - - - - - -
PRESET LOCK
PWR UP ACTION
AUTO FLIP
JOG MAX SPEED
JOG DIRECTION
FRZ IN PRESET
<PARKING ACTION SETUP>
<ALARM INPUT SETUP>
BACK
EXIT
Press Near/Enter Key
2
PARKING ACTION SETUP
- - - - - - - - - - - - - - - - - - - - - - - - - - -
PARK ENABLE
OFF
WAIT TIME
00: 1 0:00
PARK ACTION
HOME
BACK
EXIT
1
OFF
ON
ON
1 40/SEC
NORMAL
OFF
2
24
MOTION SETUP
Setup the general functions of pan/tilt motions.
PRESET LOCK
If motion lock is set to on, it is impossible to set up and delete preset,
scan, pattern and group. It is possible only to run those functions.
To set up and delete those functions, enter into OSD menu.
PWR UP ACTION
This function enables to resume the last action executed before power
down. Most of actions such as preset, pattern, scan and group are
available for this function but jog actions are not available to resume.
AUTO FLIP
In case that tilt angle arrives at the top of tilt orbit (90°), zoom module
camera keep moving to opposite tilt direction (180°) to keep tracing
targets. As soon as zoom module camera passes through the top of tilt
direction(90°), images should be reversed automatically and F appears
in screen. If this function is set to 'OFF', tilt movement range is 0° ~ 90°.
JOG MAX SPEED
Sets maximum jog speed. Jog speed is inversely proportional to zoom
magnification. As zoom magnification goes up, pan/tilt speed goes down.
JOG DIRECTION
If you set this to 'NORMAL', the view in the screen is moving same
direction with jog tilting. If 'INVERSE' is selected, the view in the screen
is moving reversely.
FRZ IN PRESET
At start point of preset movement, camera starts freezing the image of
start point. Camera keeps displaying the image of start point during
preset movement and does not display the images which camera gets
during preset movement. As soon as camera stops at preset end point,
camera starts displaying live images which it gets at preset end point.
This function availability should be different by models.
<PARKING ACTION SETUP>
Moves to 'PARKING ACTION SETUP' screen.
<ALARM INPUT SETUP>
Moves to 'ALARM INPUT SETUP' screen.
'<ALARM INPUT SETUP>' is displayed only analog camera.
PARKING ACTION SETUP
If 'PARK ENABLE' is set to 'ON', camera runs assigned function
automatically if there is no PTZ command during assigned
'WAIT TIME'.
PARK ENABLE
WAIT TIME
The time is displayed with "hh:mm:ss" format and you can change this
by 1 sec. unit.
1. To place the cursor on the time marked as below, press near key.
00:10:00
2. Move joystick Left/Right to adjust hours, minutes and seconds.
3. Move joystick Up/Down to select the digit.
4. By pressing near key, save current setting.
PARKING ACTION
Ex) If 'HOME' is selected for park action, camera will move to home
position when there is no PTZ command during the assigned
'WAIT TIME.'
Advertisement
Table of Contents
