Attaching Rubber Feet; Power On; Network Applications - Waters Network Systems MS1008-2G-4POE Operating Manual

3.6.1 Attaching Rubber Feet

1. Make sure the mounting surface on the bottom of the switch is free of grease and
dust.
2. Remove adhesive backing from the rubber feet.
3. Apply the rubber feet to each corner on the bottom of the switch.

3.6.2 Power On

Connect the power cord to the AC power socket on the rear panel of the switch. Check
the power indicator on the front panel to see if power is properly supplied.
4.0

Network Applications

This section provides samples of network topology in which the GSM2109/1009 switch
can be used. This model switch is generally used as a desktop, workgroup or edge
segment switch.
Desktop Application
The switch provides an ideal solution for small workgroups. The switch can be used as a
standalone switch to which personal computers, servers, and print servers are directly
connected to form a small workgroup.
Figure 4.1 – Workgroup/Classroom Application
Waters Network Systems MS1008-2G-4POE/PSX1008-2G-4PoE User's Manual Page 18