Troubleshooting Multicast Routing And Forwarding; Static Multicast Route Failure; Multicast Data Fails To Reach Receivers - HP 6125G Configuration Manual

The output shows that Switch A is the RPF neighbor of Switch C and the multicast data from Switch A is
delivered over an IPv4 over IPv4 tunnel to Switch C.

Troubleshooting multicast routing and forwarding

Static multicast route failure

Symptom
No dynamic routing protocol is enabled on the routers, and the physical status and link layer status of
interfaces are both up, but the static multicast route fails.
Analysis
If the static multicast route is not configured or updated correctly to match the current network
•
conditions, the route entry and the configuration information of static multicast route do not exist in
the multicast routing table.
If a better route is found, the static multicast route might also fail.
•
Solution
Use the display multicast routing-table static command to view the information of static multicast
1.
routes to verify that the static multicast route has been correctly configured and that the route entry
exists in the multicast routing table.
Check the type of the next hop interface of the static multicast route. If the interface is not a
2.
point-to-point interface, be sure to specify the next hop address for the outgoing interface when
you configure the static multicast route.
Check that the static multicast route matches the specified routing protocol. If a protocol was
3.
specified in static multicast route configuration, enter the display ip routing-table command to
check if an identical route was added by the protocol.
Check that the static multicast route matches the specified routing policy. If a routing policy was
4.
specified when the static multicast route was configured, enter the display route-policy command
to check the configured routing policy.

Multicast data fails to reach receivers

Symptom
The multicast data can reach some routers but fails to reach the last-hop router.
Analysis
If a multicast forwarding boundary has been configured through the multicast boundary command, any
multicast packet will be kept from crossing the boundary.
Solution
Use the display pim routing-table command to verify that the corresponding (S, G) entries exist on
1.
the router. If yes, the router has received the multicast data. Otherwise, the router has not received
the data.
Use the display multicast boundary command to check the multicast boundary information on the
2.
interfaces. Use the multicast boundary command to change the multicast forwarding boundary
setting.
74