HP 6125G Configuration Manual page 372

The IPv6 multicast source belongs to IPv6 PIM-SM 1 and the receiver belongs to IPv6 PIM-SM 2.
•
• The VLAN-interface 101 of Switch A and Switch B must be configured as the C-BSR and C-RP of the
IPv6 PIM-SM domains.
Enable the imbedded RP function for all switches in IPv6 PIM domain.
•
Figure 95 Network diagram
Device
Source
Switch A
Switch B
Configuration procedure
Enable IPv6 and configure IPv6 addresses for interfaces. (Details not shown.)
1.
Configure OSPFv3. (Details not shown.)
2.
Enable IPv6 multicast routing, IPv6 PIM-SM and MLD, and configure an IPv6 PIM-SM domain
3.
border:
# Enable IPv6 multicast routing on Switch A, and enable IPv6 PIM-SM on each interface.
<SwitchA> system-view
[SwitchA] multicast ipv6 routing-enable
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] pim ipv6 sm
[SwitchA-Vlan-interface100] quit
[SwitchA] interface vlan-interface 101
[SwitchA-Vlan-interface101] pim ipv6 sm
[SwitchA-Vlan-interface101] quit
The configuration on Switch B and Switch D is similar to the configuration on Switch A.
# Enable IPv6 multicast routing on Switch C, enable IPv6 PIM-SM on each interface, and enable
MLD on the host-side interface VLAN-interface 200.
<SwitchC> system-view
Interface IP address
N/A 1002::100/64
Vlan-int100 1002::1/64
Vlan-int101 1001::1/64
Vlan-int101 1001::2/64
Vlan-int102 2001::1/64
Vlan-int103 2002::1/64
Device Interface
Switch C Vlan-int200
Vlan-int102
Vlan-int104
Switch D Vlan-int103
Vlan-int104
361
IP address
3002::1/64
2001::2/64
3001::1/64
2002::2/64
3001::2/64