HP 6125G Configuration Manual page 151

Configure OSPF on the switches in the PIM-SM domain to make sure they are interoperable at the
2.
network layer. (Details not shown.)
Enable IP multicast routing, IGMP and PIM-SM:
3.
# Enable IP multicast routing on Switch A, enable IGMP on VLAN-interface 100, and enable
PIM-SM on each interface.
<SwitchA> system-view
[SwitchA] multicast routing-enable
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] igmp enable
[SwitchA-Vlan-interface100] pim sm
[SwitchA-Vlan-interface100] quit
[SwitchA] interface vlan-interface 101
[SwitchA-Vlan-interface101] pim sm
[SwitchA-Vlan-interface101] quit
[SwitchA] interface vlan-interface 102
[SwitchA-Vlan-interface102] pim sm
[SwitchA-Vlan-interface102] quit
# Enable IP multicast routing, IGMP and PIM-SM on Switch B and Switch C in the same way.
(Details not shown.)
# Enable IP multicast routing and PIM-SM on Switch D and Switch E in the same way. (Details not
shown.)
Configure a C-BSR and a C-RP:
4.
# On Switch D, configure the service scope of RP, specify a C-BSR and a C-RP, and set the hash
mask length to 32 and the priority of the C-BSR to 10.
<SwitchD> system-view
[SwitchD] acl number 2005
[SwitchD-acl-basic-2005] rule permit source 225.1.1.0 0.0.0.255
[SwitchD-acl-basic-2005] quit
[SwitchD] pim
[SwitchD-pim] c-bsr vlan-interface 105 32 10
[SwitchD-pim] c-rp vlan-interface 105 group-policy 2005
[SwitchD-pim] quit
# On Switch E, configure the service scope of RP advertisements, specify a C-BSR and a C-RP, and
set the hash mask length to 32 and the priority of the C-BSR to 20.
<SwitchE> system-view
[SwitchE] acl number 2005
[SwitchE-acl-basic-2005] rule permit source 225.1.1.0 0.0.0.255
[SwitchE-acl-basic-2005] quit
[SwitchE] pim
[SwitchE-pim] c-bsr vlan-interface 102 32 20
[SwitchE-pim] c-rp vlan-interface 102 group-policy 2005
[SwitchE-pim] quit
Verifying the configuration
# Display PIM configuration information on Switch A.
[SwitchA] display pim interface
Interface NbrCnt HelloInt DR-Pri
140
DR-Address