Configuring Join/Prune Message Sizes - HP 6125G Configuration Manual

Configuring IPv6 PIM common timers on an interface
Step
1. Enter system view.
2. Enter interface view.
3. Configure the hello interval.
4. Configure the maximum delay
between hello messages.
5. Configure the join/prune
interval.
6. Configure the join/prune
timeout time.
7. Configure assert timeout time.

Configuring join/prune message sizes

A large size of a join/prune message might result in loss of a larger amount of information if a message
is lost. You can set a small value for the size of each join/prune message to reduce the impact in case of
the loss of a message.
By controlling the maximum number of (S, G) entries in a join/prune message, you can effectively reduce
the number of (S, G) entries sent per unit of time.
IMPORTANT:
If IPv6 PIM snooping–enabled switches are deployed in the IPv6 PIM network, be sure to set a value no
greater than the IPv6 path MTU for the maximum size of each join/prune message on the receiver-side
edge IPv6 PIM devices.
To configure join/prune message sizes:
Step
1. Enter system view.
2. Enter IPv6 PIM view.
3. Configure the maximum size
of each join/prune message.
4. Configure the maximum
number of (S, G) entries in a
join/prune message.
Command
system-view
interface interface-type
interface-number
pim ipv6 timer hello interval
pim ipv6 triggered-hello-delay
interval
pim ipv6 timer join-prune interval
pim ipv6 holdtime join-prune
interval
pim ipv6 holdtime assert interval
Command
system-view
pim ipv6
jp-pkt-size packet-size
jp-queue-size queue-size
318
Remarks
N/A
N/A
Optional.
30 seconds by default.
Optional.
5 seconds by default.
Optional.
60 seconds by default.
Optional.
210 seconds by default.
Optional
180 seconds by default.
Remarks
N/A
N/A
Optional.
8100 bytes by default.
Optional.
1020 by default.