HP 6125G Configuration Manual page 189

[SwitchB] interface Vlan-interface 101
[SwitchB-Vlan-interface101] pim sm
[SwitchB-Vlan-interface101] quit
[SwitchB] interface loopback 0
[SwitchB-LoopBack0] pim sm
[SwitchB-LoopBack0] quit
[SwitchB] interface loopback 10
[SwitchB-LoopBack10] pim sm
[SwitchB-LoopBack10] quit
[SwitchB] interface loopback 20
[SwitchB-LoopBack20] pim sm
[SwitchB-LoopBack20] quit
# Enable IP multicast routing, IGMP and PIM-SM on Switch A, Switch C, Switch D, and Switch E
in the same way. (Details not shown.)
Configure C-BSRs and C-RPs:
4.
# Configure Loopback 10 as a C-BSR and Loopback 20 as a C-RP on Switch B.
[SwitchB] pim
[SwitchB-pim] c-bsr loopback 10
[SwitchB-pim] c-rp loopback 20
[SwitchB-pim] quit
# Configure a C-BSRs and a C-RP on Switch D in the same way. (Details not shown.)
Configure MSDP peers:
5.
# Configure an MSDP peer on Loopback 0 of Switch B.
[SwitchB] msdp
[SwitchB-msdp] originating-rp loopback 0
[SwitchB-msdp] peer 2.2.2.2 connect-interface loopback 0
[SwitchB-msdp] quit
# Configure an MSDP peer on Loopback 0 of Switch D.
[SwitchD] msdp
[SwitchD-msdp] originating-rp loopback 0
[SwitchD-msdp] peer 1.1.1.1 connect-interface loopback 0
[SwitchD-msdp] quit
Verifying the configuration
You can use the display msdp brief command to display the brief information of MSDP peering
relationship between the switches.
# Display brief MSDP peer information on Switch B.
[SwitchB] display msdp brief
MSDP Peer Brief Information
Configured
1
Peer's Address
2.2.2.2
# Display brief MSDP peer information on Switch D.
[SwitchD] display msdp brief
Up Listen
1 0
State Up/Down time
Up 00:10:17
Connect Shutdown
0 0
AS SA Count
? 0
178
Down
0
Reset Count
0