Configuration Procedure - HP 6125G Configuration Manual

Figure 14 Network diagram
Source
1.1.1.1/24

Configuration procedure

Configure an IP address and subnet mask for each interface as per
1.
On Router A, enable IP multicast routing, enable IGMP on GigabitEthernet 1/0/1, and enable
2.
PIM-DM on each interface.
<RouterA> system-view
[RouterA] multicast routing-enable
[RouterA] interface gigabitethernet 1/0/1
[RouterA-GigabitEthernet1/0/1] igmp enable
[RouterA-GigabitEthernet1/0/1] pim dm
[RouterA-GigabitEthernet1/0/1] quit
[RouterA] interface gigabitethernet 1/0/2
[RouterA-GigabitEthernet1/0/2] pim dm
[RouterA-GigabitEthernet1/0/2] quit
Configure Switch A:
3.
# Enable IGMP snooping globally.
<SwitchA> system-view
[SwitchA] igmp-snooping
[SwitchA-igmp-snooping] quit
# Create VLAN 100, assign GigabitEthernet 1/0/1 through GigabitEthernet 1/0/3 to this VLAN,
and enable IGMP snooping in the VLAN.
[SwitchA] vlan 100
[SwitchA-vlan100] port gigabitethernet 1/0/1 to gigabitethernet 1/0/3
[SwitchA-vlan100] igmp-snooping enable
[SwitchA-vlan100] quit
# Configure GigabitEthernet 1/0/3 to be a static router port.
[SwitchA] interface gigabitethernet 1/0/3
GE1/0/2 GE1/0/1
1.1.1.2/24 10.1.1.1/24
Router A
IGMP querier
Switch A
GE1/0/1
Host C
Receiver
VLAN 100
36
Switch B
Switch C
Host A
Receiver
Host B
Figure 14. (Details not shown.)