Port-Based Multicast Vlan Configuration Example - HP 6125G Configuration Manual

IP group address:FF1E::101
(::, FF1E::101):
MAC group(s):
MAC group address:3333-0000-0101
The output shows that MLD snooping is maintaining the router port in the IPv6 multicast VLAN (VLAN 10)
and the member ports in the sub-VLANs (VLAN 2 through VLAN 5).

Port-based multicast VLAN configuration example

Network requirements
As shown in
MLD querier. The IPv6 multicast source sends IPv6 multicast data to IPv6 multicast group FF1E::101. Host
A, Host B, and Host C are receivers of the IPv6 multicast group. The hosts belong to VLAN 2 through
VLAN 4 respectively.
Configure the port-based IPv6 multicast VLAN feature on Switch A so that Router A sends IPv6 multicast
data to Switch A through the IPv6 multicast VLAN, and Switch A forwards the IPv6 multicast data to the
receivers that belong to different user VLANs.
Figure 70 Network diagram
Configuration procedure
Enable IPv6 forwarding on each device, and configure the IPv6 address and address prefix for
1.
each interface as per
On Router A, enable IPv6 multicast routing, enable IPv6 PIM-DM on each interface, and enable
2.
MLD on the host-side interface GigabitEthernet 1/0/2.
<RouterA> system-view
[RouterA] multicast ipv6 routing-enable
[RouterA] interface gigabitethernet 1/0/1
[RouterA-GigabitEthernet1/0/1] ipv6 pim dm
Host port(s):total 0 port(s).
Host port(s):total 0 port(s).
Figure 70, MLDv1 runs on Router A. MLDv1 snooping runs on Switch A. Router A acts as the
Figure 70. (Details not shown.)
248