HP 6125G Configuration Manual page 188

Figure 56 Network diagram
Device
Source 1
Source 2
Switch A
Switch B
Configuration procedure
Configure the IP address and subnet mask for each interface as per
1.
Configure OSPF on the switches to make sure the switches are interoperable at the network-layer,
2.
and they can dynamically update their routing information. (Details not shown.)
Enable IP multicast routing, IGMP and PIM-SM:
3.
# Enable IP multicast routing on Switch B, enable IGMP on the host-side interface VLAN-interface
100, and enable PIM-SM on each interface.
<SwitchB> system-view
[SwitchB] multicast routing-enable
[SwitchB] interface vlan-interface 100
[SwitchB-Vlan-interface100] igmp enable
[SwitchB-Vlan-interface100] pim sm
[SwitchB-Vlan-interface100] quit
[SwitchB] interface vlan-interface 103
[SwitchB-Vlan-interface103] pim sm
[SwitchB-Vlan-interface103] quit
Interface IP address
— 10.110.5.100/24
— 10.110.6.100/24
Vlan-int300 10.110.5.1/24
Vlan-int103 10.110.2.2/24
Vlan-int100 10.110.1.1/24
Vlan-int103 10.110.2.1/24
Vlan-int101 192.168.1.1/24
Loop0 1.1.1.1/32
Loop10 3.3.3.3/32
Loop20 10.1.1.1/32
Device
Switch C
Switch D
Switch E
177
Interface IP address
Vlan-int101 192.168.1.2/24
Vlan-int102 192.168.2.2/24
Vlan-int200 10.110.3.1/24
Vlan-int104 10.110.4.1/24
Vlan-int102 192.168.2.1/24
Loop0 2.2.2.2/32
Loop10 4.4.4.4/32
Loop20 10.1.1.1/32
Vlan-int400 10.110.6.1/24
Vlan-int104 10.110.4.2/24
Figure 56. (Details not shown.)