Configuring Ipv6 Multicast Source Port Filtering - HP 6125G Configuration Manual

Configuring an IPv6 multicast group globally
Step
1. Enter system view.
2. Enter MLD-snooping view.
3. Configure an IPv6 multicast
group filter.
Configuring an IPv6 multicast group filer for a port
Step
1. Enter system view.
2. Enter Layer 2 Ethernet
interface view or Layer 2
aggregate interface view.
3. Configure an IPv6 multicast
group filter.

Configuring IPv6 multicast source port filtering

When the IPv6 multicast source port filtering feature is enabled on a port, the port can connect only to
IPv6 multicast receivers rather than multicast sources. The reason is that the port blocks all IPv6 multicast
data packets but it permits multicast protocol packets to pass.
If this feature is disabled on a port, the port can connect to both multicast sources and IPv6 multicast
receivers.
Configuring IPv6 multicast source port filtering globally
Step
1. Enter system view.
2. Enter MLD-snooping view.
3. Enable IPv6 multicast source
port filtering.
Configuring IPv6 multicast source port filtering for a port
Step
1. Enter system view.
2. Enter Layer 2 Ethernet
interface view,.
Command
system-view
mld-snooping
group-policy acl6-number [ vlan
vlan-list ]
Command
system-view
interface interface-type
interface-number
mld-snooping group-policy
acl6-number [ vlan vlan-list ]
Command
system-view
mld-snooping
source-deny port interface-list
Command
system-view
interface interface-type
interface-number
221
Remarks
N/A
N/A
By default, no IPv6 group filter is
globally configured. That is, the
hosts in a VLAN can join any valid
multicast group.
Remarks
N/A
Use either command.
By default, no IPv6 group filter is
configured on an interface. That is, the
hosts on the interface can join any
valid multicast group.
Remarks
N/A
N/A
Disabled by default
Remarks
N/A
Use either command.