HP 6125G Configuration Manual page 78

Figure 26 Network diagram
Switch A
Vlan-int200
50.1.1.1/24
Configuration procedure
Configure the IP address and subnet mask for each interface as per
1.
Enable OSPF on the switches in the PIM-DM domain to make sure the switches are interoperable
2.
at the network layer and they can dynamically update their routing information. (Details not
shown.)
Enable IP multicast routing, IGMP and PIM-DM:
3.
# Enable IP multicast routing on Switch B, enable IGMP on VLAN-interface 100, and enable
PIM-DM on each interface.
<SwitchB> system-view
[SwitchB] multicast routing-enable
[SwitchB] interface vlan-interface 100
[SwitchB-Vlan-interface100] igmp enable
[SwitchB-Vlan-interface100] pim dm
[SwitchB-Vlan-interface100] quit
[SwitchB] interface vlan-interface 101
[SwitchB-Vlan-interface101] pim dm
[SwitchB-Vlan-interface101] quit
[SwitchB] interface vlan-interface 102
[SwitchB-Vlan-interface102] pim dm
[SwitchB-Vlan-interface102] quit
# Enable IP multicast routing on Switch A, and enable PIM-DM on each interface.
<SwitchA> system-view
[SwitchA] multicast routing-enable
[SwitchA] interface vlan-interface 200
[SwitchA-Vlan-interface200] pim dm
[SwitchA-Vlan-interface200] quit
[SwitchA] interface vlan-interface 102
Vlan-int103
40.1.1.1/24
Vlan-int103
40.1.1.2/24
Vlan-int102
30.1.1.2/24
Source
50.1.1.100/24
Multicast static route
Switch C
Vlan-int101
20.1.1.2/24
PIM-DM
Vlan-int101
20.1.1.1/24
Vlan-int102
30.1.1.1/24
Receiver
10.1.1.100/24
67
Switch B
Vlan-int100
10.1.1.1/24
Figure 26. (Details not shown.)