Task
Display IGMP SSM mappings.
Display the multicast group
information created from IGMPv1
and IGMPv2 reports based on the
configured IGMP SSM mappings.
Remove all the dynamic IGMP
group entries of IGMP groups.
Remove all the dynamic Layer 2
port entries of IGMP groups.
Clear IGMP SSM mappings.
IGMP configuration examples
Basic IGMP functions configuration example
Network requirements
Receivers receive VOD information through multicast. Receivers of different organizations form stub
networks N1 and N2, and Host A and Host C are receivers in N1 and N2 respectively.
IGMPv2 runs between Switch A and N1. IGMPv2 runs between the other two switches and N2. Switch
B acts as the IGMP querier in N2 because it has a lower IP address.
The hosts in N1 can join only multicast group 224.1.1.1, and the hosts in N2 can join any multicast
groups.
Command
display igmp ssm-mapping
group-address [ | { begin |
exclude | include }
regular-expression ]
display igmp ssm-mapping group
[ group-address | interface
interface-type interface-number ]
[ verbose ] [ | { begin | exclude |
include } regular-expression ]
reset igmp group { all | interface
interface-type interface-number
{ all | group-address [ mask { mask
| mask-length } ] [ source-address
[ mask { mask | mask-length } ] ] } }
reset igmp group port-info { all |
group-address } [ vlan vlan-id ]
reset igmp ssm-mapping group
{ all | interface interface-type
interface-number { all |
group-address [ mask { mask |
mask-length } ] [ source-address
[ mask { mask | mask-length } ] ] } }
93
Available in any view.
Available in any view.
Available in user view.
This command cannot remove
static IGMP group entries.
Available in user view.
Available in user view.