Troubleshooting Msdp; Msdp Peers Stay In Down State; No Sa Entries In The Switch's Sa Cache - HP 6125G Configuration Manual

Ip multicast configuration guide
Hide thumbs Also See for 6125G:
Table of Contents

Advertisement

Troubleshooting MSDP

MSDP peers stay in down state

Symptom
The configured MSDP peers stay in the down state.
Analysis
A TCP connection–based MSDP peering relationship is established between the local interface
address and the MSDP peer after the configuration.
The TCP connection setup will fail if the local interface address is not consistent with the MSDP peer
address configured on the peer router.
If no route is available between the MSDP peers, the TCP connection setup will fail.
Solution
Verify that a route is available between the routers. Use the display ip routing-table command to
1.
determine whether the unicast route between the routers is correct.
Verify that a unicast route is available between the two routers that will become MSDP peers to
2.
each other.
Verify the interface address consistency between the MSDP peers. Use the display
3.
current-configuration command to verify that the local interface address and the MSDP peer
address of the remote router are the same.

No SA entries in the switch's SA cache

Symptom
MSDP fails to send (S, G) entries through SA messages.
Analysis
The import-source command controls sending (S, G) entries through SA messages to MSDP peers.
If this command is executed without the acl-number argument, all the (S, G) entries are filtered out.
That is, no (S, G) entries of the local domain is advertised.
If the import-source command is not executed, the system will advertise all the (S, G) entries of the
local domain. If MSDP fails to send (S, G) entries through SA messages, verify that the
import-source command has been correctly configured.
Solution
Use the display ip routing-table command to verify that the unicast route between the routers is
1.
correct.
Verify that a unicast route is available between the two routers that will become MSDP peers to
2.
each other.
Verify the configuration of the import-source command and its acl-number argument and be sure
3.
that ACL rule can filter appropriate (S, G) entries.
184

Advertisement

Table of Contents
loading

This manual is also suitable for:

6125 blade switch series

Table of Contents