HP 6125G Configuration Manual page 161

Figure 49 Network diagram
Device
Switch A
Switch B
Switch C
Configuration procedure
Configure the IP address and subnet mask for each interface as per
1.
Configure OSPF on the switches in the PIM-SSM domain to make sure they are interoperable at the
2.
network layer. (Details not shown.)
Enable IP multicast routing, IGMP and PIM-SM:
3.
# Enable IP multicast routing on Switch A, enable IGMPv3 on VLAN-interface 100, and enable
PIM-SM on each interface.
<SwitchA> system-view
[SwitchA] multicast routing-enable
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] igmp enable
[SwitchA-Vlan-interface100] igmp version 3
[SwitchA-Vlan-interface100] pim sm
[SwitchA-Vlan-interface100] quit
[SwitchA] interface vlan-interface 101
[SwitchA-Vlan-interface101] pim sm
Interface IP address
Vlan-int100 10.110.1.1/24
Vlan-int101 192.168.1.1/24
Vlan-int102 192.168.9.1/24
Vlan-int200 10.110.2.1/24
Vlan-int103 192.168.2.1/24
Vlan-int200 10.110.2.2/24
Vlan-int104 192.168.3.1/24
Device
Switch D
Switch E
150
Interface IP address
Vlan-int300 10.110.5.1/24
Vlan-int101 192.168.1.2/24
Vlan-int105 192.168.4.2/24
Vlan-int104 192.168.3.2/24
Vlan-int103 192.168.2.2/24
Vlan-int102 192.168.9.2/24
Vlan-int105 192.168.4.1/24
Figure 49. (Details not shown.)