HP 6125G Configuration Manual page 134

Step
3. Configure the BS period.
4. Configure the BS timeout
timer.
NOTE:
If you configure the BS period or the BS timeout timer, the system uses the configured one instead of the
default one.
Disabling BSM semantic fragmentation
Generally, a BSR periodically distributes the RP-set information in bootstrap messages within the PIM-SM
domain. It encapsulates a BSM in an IP datagram and might split the datagram into fragments if the
message exceeds the maximum transmission unit (MTU). In respect of such IP fragmentation, loss of a
single IP fragment leads to unavailability of the entire message.
Semantic fragmentation of BSMs can solve this issue. When a BSM exceeds the MTU, it is split to multiple
bootstrap message fragments (BSMFs).
After receiving a BSMF that contains the RP-set information of one group range, a non-BSR router
•
updates corresponding RP-set information directly.
If the RP-set information of one group range is carried in multiple BSMFs, a non-BSR router updates
•
corresponding RP-set information after receiving all these BSMFs.
Because the RP-set information contained in each segment is different, loss of some IP fragments will not
result in dropping of the entire message.
Generally, a BSR performs BSM semantic fragmentation according to the MTU of its BSR interface.
However, the semantic fragmentation of BSMs originated because of learning of a new PIM neighbor is
performed according to the MTU of the outgoing interface.
The function of BSM semantic fragmentation is enabled by default. Devices not supporting this function
might deem a fragment as an entire message and learn only part of the RP-set information. Therefore, if
such devices exist in the PIM-SM domain, you need to disable the semantic fragmentation function on the
C-BSRs.
To disable the BSM semantic fragmentation function:
Command
c-bsr interval interval
c-bsr holdtime interval
123
Remarks
Optional.
By default, the BS period is
determined by the formula "BS
period = (BS timeout timer– 10) /
2." The default BS timeout timer is
130 seconds, so the default BS
period is (130 – 10) / 2 = 60
(seconds).
The BS period value must be
smaller than the BS timeout timer.
Optional.
By default, the BS timeout timer is
determined by the formula "BS
timeout timer = BS period × 2 +
10." The default BS period is 60
seconds, so the default BS timeout
timer = 60 × 2 + 10 = 130
(seconds).