Configuring Traffic Policing (Two-Rate Color-Blind) - Cisco ASR 9000 Series Configuration Manual

Configuring Traffic Policing (Two-Rate Color-Blind)

Command or Action
Step 7
Specifies the name of the class whose policy you want
to create or change.interface type interface-path-id
Example:
RP/0/RSP0/CPU0:router(config)# interface
gigabitethernet
Step 8 service-policy {input | output} policy-map
Example:
RP/0/RSP0/CPU0:router(config-if)#
service-policy output policy1
Step 9 commit
Step 10
show policy-map interface type interface-path-id [input
| output]
Example:
RP/0/RSP0/CPU0:router# show policy-map
interface gigabitethernet
Configuring Traffic Policing (Two-Rate Color-Blind)
Traffic policing allows you to control the maximum rate of traffic sent or received on an interface. This section
provides the procedure for configuring two-rate color-blind traffic policing.
SUMMARY STEPS
1. configure
2. policy-map policy-name
3. class class-name
4. police rate {value [units] | percent percentage} [burst burst-size [burst-units]] [peak-burst peak-burst
[burst-units]] [peak-rate value [units]]
5. conform-action action
6. exceed-action action
7. exit
8. exit
9. exit
10. interface type interface-path-id
11. service-policy {input | output} policy-map
12. commit
13. show policy-map interface type interface-path-id [input | output]
Cisco ASR 9000 Series Aggregation Services Router Modular Quality of Service Configuration Guide, Release
6.1.x
82
Configuring Modular QoS Congestion Management
Purpose
Enters interface configuration mode and configures an
interface.
Attaches a policy map to an input or output interface to be
used as the service policy for that interface. In this example,
the traffic policy evaluates all traffic leaving that interface.
(Optional) Displays policy configuration information for
all classes configured for all service policies on the specified
interface.