Controlling The Backlight Of The Screen - Oce CPS900 User Manual

Controlling the backlight of the screen

Introduction
At the rear side of the operator panel you will find the 2 keys used to adjust the
backlight of the screen. You can adjust the backlight in the range 0 to 7. Default value
is 4.
The keys are not repetitive (no repeat function).
The system keeps the backlight setting in the memory. A restart of the system has no
influence on this setting.
Before you begin
Wait until the machine has passed the initialisation phase. You will see the basic
screen settings when the initialization phase is completed and the Océ CPS900
in Stand-by mode.
The figure below shows you where to find the keys for the backlight control. The
keys to operate the backlight control are located at the rear of the monitor where the
arrow marks the position.
Illustration
[12]
[12] Backlight control
How to control the backlight of the screen
Press the right backlight key.
1.
The brightness level increases one step.
Press the right key again until you reach the needed level of brightness.
2.
If you want to decrease the brightness, follow steps 1 and 2 but use the left backlight
3.
key instead.
Controlling the backlight of the screen
®
is
45