Use Coated Paper - Oce CPS900 User Manual

Use coated paper

Use coated paper
Introduction
Coated material requires a special treatment. The characteristics of coated material
will change when the material is heated. The heat will make the material weak.
Because of the weakness of the material, the printer must be prepared to deliver the
output correctly.
For proper use of coated materials the operator must adjust the coated material guide
in the lower output tray. This adjustment is not necessary in the upper tray.
When you select a job that contains coated material, the display will give you no
warning to adjust the coated material guide.
The coated material guide can be placed in two positions (active and not active).
Active indicates that the guide is raised and that coated material is supported.
Inactive indicates that the guides are lowered and coated material will not be
delivered properly.
When to do
Activate the coated paper guides, when...
you print on coated materials (always).
you notice gathering problems in the lower output tray for specific thin, flexible
or sticky print materials.
112 Chapter 6 Maintenance