Oce CPS900 User Manual page 78

Defining Extended Print Settings
[33] Layout Settings
78 Chapter 3 Print Jobs on the Océ CPS900®
'Image shift'
'Shift to center' You can use this setting to put an image into the center
of the print. For example, if the print is smaller than the
original.
If the original is too large, 'Shift to center' determines
the part that is copied.
The front/back margin setting indicates the move of
the image on the front and the back of the print with
respect to the binding edge. You can move the
margin from -100 mm / -4 inches to +100 mm / + 4
inches. Use 'Margin shift' for example to bind or
punch a document.
The setting for 'Back' is only available for a 2-sided
print.
The 'Registration' indicates the move (front and
back side of the sheet) of the image with respect to
feeding edge of the paper, this is the long edge for
LEF sheets and the short edge for SEF sheets. There
is one value for both the front of the print and the
back of the print (–5.0 mm / –0.2 inches to +5.0 mm
/ +0.2 inches). The image on the front and back side
are moved in opposite direction.
Note: Bear in mind that if you select an
image shift of -1 mm /-.4 inches, the images
on front and back are moved .5 mm / .2
inches (!) to the left of the feeding edge. The
result allows you to align the images with
respect to each other.
'Yes': The image is printed into the center.
'No': The image is printed in the upper left corner.
'Yes': The center of the original is copied.
'No': The upper left corner of the original is copied.
The upper right corner of the back of the original is
copied.
(2 – 2)