Oce CPS900 User Manual page 86

How to stop a job
Stop while the operator defines the settings for a job
[37]
[37] Stop behavior while the operator defines the settings for a job
If the Correction key (
pressed ...
one time
two times
three times
Note: Remember the following: When the operator uses set-build, the Correction
key ( ) has a different function. Press one time, the number of prints is set to 1.
Press two times, all the settings are set to the default value of the template. Each next
time the Correction key (
86 Chapter 3 Print Jobs on the Océ CPS900®
) is Then ...
the number of prints is set to 1
all the settings are set to the default value of the
template
the operator panel returns to the main screen
with the standard templates
) is pressed, the last subset is deleted.