Oce CPS900 User Manual page 40

Adjust the System manager settings
[17]
[17] The workflow settings
'Workflow' menu Description
'Set account
number'
'Check first set'
'Save settings'
'Deposit behavior'
'Processing'
40 Chapter 1 Introduction
The value always shows the current system account number.
If a job has no account number and the 'Accounting behavior'
is set to 'Job or System', the system account number is used
for the job. If the operator manually specified an account
number when the job was created, the job account number is
used instead of the system account number.
If the 'Accounting behavior' is set to 'System' the system
account number is always used (if an account number was
specified when the print job was created, this number will be
overruled by the system account number).
The setting indicates whether a check print should be made
(Yes) or not (No) for all print jobs. In the 'System manager',
define the default value.
This setting indicates that changed job settings are saved in
the mailbox. In the 'System manager', define the default
value.
This setting indicates whether the lower and upper tray must
be linked (overflow).
'Use job setting'
The job goes into the tray as specified in the job settings
'Overflow'
If the lower tray is full, the printer uses the upper tray to
continue.
If 'Overflow' is selected, you cannot select the output
destination (upper or lower output tray) in the print job,
(see 'Make Extended Print Settings, Output' in the Job
Manual).
'Keep sequence': The system will always print the jobs in the
same order as displayed in the job queue. If a job cannot start
printing, the system will stop. No jobs will be printed.
'Keep going': The system will always try to keep producing.
If a job in the job queue cannot start printing, because the job
is on hold or has a start contradiction, other jobs in the job
queue may overtake that job and be sent to print.