Installation; Hardware - Emerson Dixell X-web300 Operation Manual

2 I N S T A L L A
2 I N S T A L L A

2.1 HARDWARE

ATTENTION: to protect both yourself and the server from electrical hazards the XWEB should remain turned
off until you are finished connecting all electrical devices to the unit.
To avoid accidental start of the unit, remember to plug in electrical cable only when you have
finished setting up all other connection.
3
: alarm relay 1 (**)
4
5
: alarm relay 2 (**)
6
7
: System alarm relay
:7-8 Alarm
8
:7-9 Alarm present
9
15
: digital input (**)
16
-
12 ( )
+
13 ( )
: RS 485
14 ()
Led
Alarm
Rec
Power
Status
System
Alarm2
Alarm1
(*)= 12Vcc - 250mA. Modem supported TC35-KIT (Siemens TC55i)
(**)= only for XWEB500DIN
WARNING: The status of led system is directly linked to the status of the relay "System alarm".
WARNING: with XWEB300D the 'system relay' acts as AUX taking following logic:
• at rest (XWEB off) closed contacts 7:09
• in case of alarm closes on 7-8
• turning on for a few seconds closes on 7-8. then if there are no alarms back to rest and closing on 7-9.
1592028000 XWEB300D_500_500D opr GB r2.2.0 2013.08.01.docx
T I O N
T I O N
(ONLY FOR DIN MODELS)
Red
Orange
Green
Green
Red
Red
Red
: 1-2 XWEB500 Power supply
: 10-11 External GSM modem power
supply (*)
: USB external peripherals
: COM port for external modem
: Telephone jack (only for internal
modem)
: RJ45 LAN connector
LED
Color
RS485 Alarm
Data recording
System turned on
Messages are being sent
System alarm
Alarm Relay 2 status
Alarm Relay 1 status
XWEB500/300
Description
11/114