Modem Setup; Dialup Setup - Emerson Dixell X-web300 Operation Manual

2.3.8 MODEM SETUP

Next window allows you to setup the modem
connection. XWEB uses the modem to send
faxes and in same cases also e-mails. In the
first case the unit itself can send a fax, while
in the second case you may need to setup a
dial-up connection (next step).
When XWEB modem is in use, it is
important to choose the country according to
the real country where XWEB is installed.
From the drop down menu "country", choose
yours (either internal or external one, but
also both of them). Please choose your
country to avoid modem malfunctioning. If
your country is not available in the supported
list, please contact Dixell. XWEB can
manage up to 2 modem simultaneously:
enable/disable them according to your real
application. Remember also to set "Dial-in
calls" and the number of rings before the
answer of the modem.
To use a XWEB model with integrated
modem (GPRS), select 'internalGSM' in the
"internal modem" section and enable the
calls from internal modem in the "incoming
calls" section. This function is available only
for DIN models.

2.3.9 DIALUP SETUP

Click on "Dial up" to proper setup the internet
connection for sending e-mails. You need a
valid internet account, then fill in all the field.
If you do not have a valid SMTP Server, once
connected to the Internet, XWEB will try to
send the e-mail directly to the receiver. This
type of operation is NOT support by all ISP
(internet service provider). For this reason it
is strongly recommended to use a valid
SMTP.
When using a GPRS modem integrated in
XWEB, the dial-up line does not work.
Instead, configure the "GPRS configuration"
that follows in the same page.
For a complete configuration example for a
GPRS configuration see appendix D.
1592028000 XWEB300D_500_500D opr GB r2.2.0 2013.08.01.docx XWEB500/300 31/114