Alarm Levels - Emerson Dixell X-web300 Operation Manual

Click on "Cancel All";
Confirm the operation if necessary. Wait for the screen refresh.
To reset the form

Click on "new".
For each receiver the calendar function is also suitable to enable the alarm sending procedure only during
certain period of time. See Calendar chapter.
3.3.4.3

ALARM LEVELS

The alarm levels are organised as a list of items. Each named level provides to execute the right procedure
to transfer the alarm notification to the receiver or receivers. They act just like a filter.
E.g: an alarm belonging to the "Temperature alarm" typology can be differently treated from the "no-link"
alarm so as the destination and the kind of message is suitable to a proper information about the alarm event
itself. The alarm level also assigns the number of receivers and the transmission mode (Fax and E-mail). It is
also possible to switch on/off the status of the onboard relay (only for XWEB500DIN). Check/uncheck AUX1
or AUX2 in the proper page. In the back of the unit you can find the relay outputs.
WARNING: Terminal blocks for relays AUX1 and AUX2 can not be used for
switching high voltage loads (24V or higher). Use a low voltage
circuit to manage your loads.
The easiest method to work with levels is to define three kinds of alarms corresponding to "Severe alarm",
"Standard alarm", "Warning". Each alarm typology, depending on its importance, can be linked to one of this
three alarm level to alert different personnel.
It is also allowed to define as many alarm levels as the existing alarm typology in order to transfer complete
information about each alarm origin.
Under the device configuration paragraph you will learn how to assign the designed alarm typologies and
alarm levels to each instrument.
This multilevel structure gives the maximum flexibility and it comes to solve every kind of alarm management
problem.
The "XJR40D Configuration" appears to the user only if you have configured the system to a module
XJR40D for the extension of alarm notifications with relays (Configuration menuSystemSystem). You
can for example set it up on for four distinct levels reporting for example "high temperature NT", "high
temperature LT", "failure rack NT", "failure rack LT".
 Insert a new Alarm Level and the attributes
Click into "Name" and insert the word(s) that better represents the alarm e.g.: "Severe Alarm".
To insert the Receiver

Select the Receiver.
Click the kind of procedure to send the alarm (Fax, E-mail).
Click on "Insert" to add the new item.
To modify an item

Select the item from the "Selection" roll down menu.
1592028000 XWEB300D_500_500D opr GB r2.2.0 2013.08.01.docx XWEB500/300 49/114