Remote Connection From A Client Pc; Modem Connection ("Or Point To Point Connection"); Intranet / Ethernet Connection - Emerson Dixell X-web300 Operation Manual

2.1.7 REMOTE CONNECTION FROM A CLIENT PC

2.1.7.1

MODEM CONNECTION ("OR POINT TO POINT CONNECTION")

It represents the most common method where the LAN (intranet / Ethernet / internet) is not available.
It is strongly advised to use a dedicated telephone line.
IMPORTANT: Use exclusively modem devices approved by Dixell.
Remember that many modems are not compatible with Linux. The list of compatible models can
be found under the menu: Configuration – System - Modem. In appendix E, you can find the
complete list of accessories together with their commercial name. Dixell can provide you these modems. You
can decide to buy them in your country, but do not use different models from the ones stated here. Dixell is
not responsible for any action depending on a modem that is not present in the official list of supported
accessories.
External Modem.
Connect the modem to the COM Port on the back side using the modem cable commonly included into the
modem packaging itself.
The reset of XWEB modem is directly controlled by the XWEB Server through the COM port, but if you use a
GSM modem remember to use the external relay to cut the modem power supply to reset it.
Connect the modem to the telephone line with the phone cable included into the modem packaging.
Remember to check if there is a switching machine (add the prefix digit). The connection procedure is
divided in two parts:
In the first part it is necessary to create the Remote Access, in your remote PC, set with the telephone
number of the line where the XWEB is connected to. You have to use Dixell as Username and Password.
The second is the procedure you will ever use: after launching the new Remote Access that will engage the
line via the modem, start the Browser from your PC and insert the address
Explorer/Netscape address bar. Proper information about setting up a dial-up connection for the client PC,
can be found inside the INSTALLATION MANUAL on §4.3.
2.1.7.2

INTRANET / ETHERNET CONNECTION

The Intranet or Ethernet connection should be initially managed by the net administrator which will assign
one free IP address to reach the Server. This number is an example of what you should expect:
http://192.168.000.111.
After receiving the address from your network Administrator the XWEB must be set with this number.
Use a standard RJ45 network cable to connect the unit to your existing LAN.
The Intranet method allows the connection to interact with XWEB from all the PC Clients. Insert the net
address assigned by the administrator into the Browser address bar. Bookmark the address with
personalised name for the future connections.
1592028000 XWEB300D_500_500D opr GB r2.2.0 2013.08.01.docx XWEB500/300
http://192.168.0.150
15/114
into