Setting Close Direction - Genie GCL-J&H Installation Manual

Setting Close Direction

The direction of motor rotation depends on mounting position and/or how the
main input power phases are wired. This setting is used to insure the door is
closing and opening according to the input commands.
1) If operator is in RUN mode, press CAL/RUN
SET
2) Press SET/CLEAR key to begin the calibration procedure and advance to
CLEAR
the next screen. Figure 3.
3 ) Briefly press the CLOSE
this control function.)
The display will read " DID DOOR CLOSE? " Figure 4.
4) Press SCROLL key (up or down) to toggle between YES and NO.
SCROLL
Figure 5.
• If YES is selected, no change to operator calibration is made. If
NO is selected — the POD will change the operator's down direction.
SET
5) Press the SET/CLEAR
CLEAR
CAL
6) Press CAL/RUN key to return to run mode.
RUN
GCL-J&H
Standard Duty Operator
key to enter calibration mode.
CAL
RUN
key. (Pressing the Scroll key at this point will exit
CLOSE
SCR LL
LO E
O
C AR
key.
www.geniecompany.com
Figure 2
CAL
Figure 3
CAL
Figure 4
DID DOOR CLOSE?
CAL
Figure 5
SCROLL KEY
CAL
RUN
OPEN
SET CLOSE DIR
CLOSE
STOP
SET
OPEN
HIT CLOSE KEY
CLOSE
STOP
SET
OPEN
CLOSE
STOP
SET
OPEN
YES NO
CLOSE
STOP
SET
SCROLL
CLEAR
SCROLL
0 -12
6.2