Setting Braking Rate - Genie GCL-J&H Installation Manual

Setting Braking Rate

1) If operator is in RUN mode, press CAL/RUN
2) Press Scroll key until display reads "BRAKING RATE >#." where # is the
CROLL
deceleration rate, ranging from 0 to 9. 0=max. braking. 9=Min.
Figure 6.
3) Press SET/CLEAR SET key to toggle between 0 and 9—one digit at a time.
CLEAR
4) Pick a value and operate the door. Adjust as necessary.
5) Press a SCROLL key to shift to a new function and lock in the setting.
SCROLL
6) Press CAL/RUN key to return to run mode.
CAL
RUN
GCL-J&H
Standard Duty Operator
CAL key to enter calibration mode.
RUN
www.geniecompany.com
OPEN
BRAKING RATE 0
CLOSE
STOP
CAL SET
SCROLL
RUN CLEAR
SCROLL
Figure 6
0 -12 6.3