(Optional) Transmitter Programming - Genie GCL-J&H Installation Manual

(Optional) Transmitter Programming

Adding a Transmitter
1) If operator is in RUN mode, press CAL/RUN
2) Press SCROLL key (up or down) until display reads "LEARN NEW XMTR? "
SCROL
Figure 13.
C
This question along with the instruction "HIT SET FOR YES" will
continuously pan across the display window. (Pressing SCROLL or
SE
CAL/RUN will cancel the operation.) CL AR
3) Press SET/CLEAR SET key.
CLEAR
Display will read "PUSH XMTR BUTTON TWO TIMES TO LEARN XMTR."
4) Press Transmitter button two times.
The display will read "XMTR ___LEARNED." Where it assigns a random
number between 1 and 50 to the transmitter. That transmitter is
entered and ready to operate the door. (Label/mark the transmitter.)
5) Press SCROLL key (up or down) to move on to another menu item,
SCROLL
or CAL/RUN key to exit the CAL mode.
CAL
RUN
Removing Individual Transmitter
1) If operator is in RUN mode, press CAL/RUN
2) Press SCROLL key (up or down) until display reads "REMOVE XMTR? "
SCROLL
Figure 14
This question along with the instruction "HIT SET FOR YES" will
continuously pan across the display window. (Pressing SCROLL or
CAL/RUN will cancel the operation.)
SET
3) Press SET/CLEAR key.
CLEAR
A menu displaying the available transmitter numbers will appear.
Press SCROLL key (up or down) to cycle through the menu to the
SCROLL
number of the transmitter to be removed. (Pressing CAL/RUN will
cancel the operation.)
4) Press SET/CLEAR SET key.
CLEA
The transmitter is removed.
5) Press SCROLL SCROLL key (up or down) to move on to another menu item,
or CAL/RUN key to exit the CAL mode.
CAL
RUN
GCL-J&H
Standard Duty Operator
CAL
key to enter calibration mode.
RUN
C
LO
CAL
key to enter calibration mode.
RUN
C L
L E
www.geniecompany.com
LEARN NEW XMTR?
CAL
Figure 13
REMOVE XMTR?
CAL
Figure 14
REMOVE ALL XMTRS?
CAL
Figure 15
Removing All Transmitters
1) If operator is in RUN mode, press CAL/RUN
2) Press SCROLL key (up or down) until display reads "REMOVE ALL XMTRS"
CROLL
Figure 15.
S O L
This question along with the instruction "HIT SET FOR YES" will
continuously pan across the display window. (Pressing SCROLL or
CAL/RUN will cancel the operation.)
3) Press the SET/CLEAR SET key.
CLEAR
The display will read "ARE YOU SURE."
SET
4) Press the SET/CLEAR key.
CLEAR
All transmitters are removed.
5) Press SCROLL SCROLL key (up or down) to move on to another menu item,
CAL
or CAL/RUN key to exit the cal mode.
RUN
CLOSE
STOP
SET
CLOSE
STOP
SET
CLOSE
STOP
SET
CAL
key to enter calibration mode.
RUN
0 -12
6.8