Installation; Front Of Hood - Genie GCL-J&H Installation Manual

Front of Hood

The Rolling Steel Door Operator can be assembled for right-hand or
left-hand mounting Front of Hood.
wall mounted. Page 4.2)
NOTE:
On Jackshaft units, release cable must be installed on operator
before unit is installed.
1) Attach mounting brackets (112145.0001) to operator using
5/16" hex nuts and bolts.
2) Attach operator and mounting brackets (112145.0001) to
large angle power support bracket using 5/16"-18 hex nuts and bolts.
3) Attach assembly to head plate with 7/16"-14 socket button head
cap screws and hex nuts. Finger tight.
4) Install 12 tooth #50 sprocket on output shaft of operator,
and #50 door sprocket on door shaft.
5) Align the door sprocket and operator output sprocket and
wrap #50 roller chain around both. Lock sprockets in place
by tightening their set screws.
6) Tension the drive chain by pulling the operator through the
slot in the power support bracket and tighten cap screws and nuts.
GCL-J&H
Standard Duty Operator
Section 4: Installation
Fig. 1. (Each model can also be
www.geniecompany.com
112145.0001
(GSX Mounting Bracket)
Figure 1
SOCKET BUTTON
HEAD CAP SCREW
086480.2018
(Hex nut w/lkwshr, 5/16-18)
086420.0506
(Bolt, 5/16-18 x 3/4)
SOCKET BUTTON
HEAD CAP SCREW
080352.0714
(Hex nut, 7/16-14)
FLAT WASHER
347372
(Power Support Bracket)
0 -12
4.1