Setting Down Limit - Genie Pro Series Installation, Programming, & Operation

WARNING
!
Make sure doorway is in full view and clear of obstacles and
people to avoid injury or property damage.
DO NOT operate this unit from the wall control before LIMITS are
set. Severe damage to the opener could occur.
DO NOT set limits with Battery Backup attached. AC power
MUST be connected to the opener while setting limits for proper
operation.
!
NOTE: Door MUST be engaged to the
opener prior to programming. Door should rest
somewhere between full open and closed. DO
NOT START WITH DOOR FULLY OPEN OR CLOSED.
TO ENGAGE DOOR
TO OPENER:
Pull release cable and
release to retract cable
and engage opener.
Programming DOWN Limit:
1. Press and hold the DOWN arrow button on the
opener for 2-5 seconds.
The LONG LED will turn BLUE. Release button.
LONG
The LED will then flash BLUE.
2. Press and hold the DOWN arrow button until door
is fully closed.
Use both UP and DOWN buttons to adjust close travel
as necessary.
Door should rest on the floor until the weather strip is
compressed enough to seal along the width of the door.
Damaged doors or uneven floors may not seal properly.
Repair these conditions to achieve a proper seal. DO NOT
compress seal so much that the door will bend or buckle.
3. Press and release the SET/PRGM button
Both LEDs will flash BLUE then go out.
The DOWN limit is now programmed.
IF DOWN LIMIT SETTING IS ALTERED, ALL FOLLOWING STEPS ON PAGES 19 THROUGH 20 MUST BE
PERFORMED TO LOCK IN THE FORCE PROFILE FOR PROPER DOOR OPERATION.
18
PROGRAMMING THE DOWN LIMIT
!
S'assurer que le passage de la porte est visible et dégagé, à savoir
sans obstacles ni personne afin d'éviter toute blessure potentielle
ou dommage matériel.
NE PAS utiliser cette unité avec la console murale avant d'avoir
réglé les LIMITES. L'ouvre-porte pourrait subir de sérieux
dommages.
NE PAS fixer de limites en mode batterie de secours.
L'alimentation CA DOIT être branchée sur l'ouvre-porte, pendant
le réglage des limites, pour assurer un bon fonctionnement.
1-2. Enter Programming Mode
Steady Blue
Flashing Blue
3. Adjust Door Position
4. Lock Programming
Flashing Blue
IMPORTANT NOTICE
AVERTISSEMENT
!
!
HOLD
UNTIL
LED
Lights
RELEASE
PRESS
&
RELEASE