Sectional Door Chart - Genie GCL-J&H Installation Manual

Model HP UL L is ted
GCL-J&H 1/2 Y es
GCL-J&H 3/4 Y es
GCL-J&H 1
Y es
T=Trolley S=Jackshaft,SideMount C=Jackshaft,CenterMount
Note: Total door weight, and not the square footage, is the critical factor in selecting the proper operator.
Square footage measurements are based on "square doors." (Example=16' x 16')
NOTE: Doors that require special windloading and wide doors, normally require increased strutting (reinforcement). Strutting doors can significantly increase door
weight beyond weight shown. Consult Customer Service for the impact of wind load andstrutting on square foot limits.
NOTE: "PU-FIP" stands for "polyurethane, foamed-in-place." If no notation is present, insulation is "polystyrene, layed-iin-place."
1) READ AND FOLLOW ALL INSTALLATION INSTRUCTIONS.
2) Install only on a properly operating and balanced door. A door that is operating
improperly could cause severe injury. Have qualified service personnel make
repairs to cables, spring assemblies and other hardware before installing the operator.
3) Remove all pull ropes and remove, or make inoperative, all locks (unless mechanically
and/or electronically interlocked to the power unit) that are connected to the door
before installing the operator.
GCL-J&H
Standard Duty Operator
Section 3: Critical Installation Information
Sectional Door Chart (sq. ft.)
CommercialSteelInsulated&Non-Insulated
Door S eries ->
216 216 ins. 220
Max. 16GA.
16GA. 20GA.
Door Flush
Mounting
Flush Ribbed
Type Weight Steel
Steel Steel
(Lbs) Insulated
TSC 1120 256 220 370
TSC 1370 330 256 440
TSC 1620 380 280 500
IMPORTANT INSTALLATION INSTRUCTIONS
WARNING -To reduce the risk of severe injury or death:
www.geniecompany.com
220 ins. 2415 2415 ins. 2411 2411 ins.
20GA. 24GA. Nominal Nominal
24GA.
Ribbed Ribbed 24GA. 24GA.
Ribbed
Steel Steel Ribbed Ribbed Steel
Steel
Insulated Insulated Steel Insulated
256 440 340 320 320
310 530 400 320 320
370 570 410 320 320
4) Install door operator at least 8 feet above floor if operator has exposed moving parts.
5) Do not connect the door operator to the power source until instructed to do so.
6) Locate the control station: (a) within sight of door, (b) a minimum of 5 feet above
floor so that small children cannot reach it, and (c) away from all moving parts of door .
7) Install the Entrapment Warning Placard next to the control station and in a
prominent location.
8) For products having a manual release, instruct the end user on the operation of the
manual release.
Thermospan Thermomark
125 150 200 200-20 5150 5200
PU/FIP PU/FIP PU/FIP
Insulated Insulated Insulated
PU/FIP PU/FIP PU/FIP
2" Raised Raised
Insulated Insulated Insulated
20GA. Panel Panel
1.38" 2"
Exterior 1.38"
256 360 400 300 400
256 450 450 370 460
256 480 480 420 500
0 -12
Aluminum
451 452
1/4" or 1/2"
1/8" Glass
Glass
1.38"
1.38"
2"
380 360 240
440 400 330
480 400 400
3.3