Setting Close Direction - Genie GCL-GCX Manual

Setting Close Direction

The direction of motor rotation depends on mounting position. This setting is
used to insure the door is closing and opening according to the input commands.
1) If operator is in RUN mode, press CAL/RUN
2) Press SCROLL until "SET CLOSE DIR" is displayed. Figure 2.
SCROLL
2) Press SET/CLEAR SET to begin the calibration procedure and advance to
CLEAR
the next screen. Figure 3.
3 ) Briefly press the CLOSE
this control function.)
• The display will read " DID DOOR CLOSE? " Figure 4
4) Press SCROLL key (up or down) to toggle between YES and NO.
SCROLL
Figure 5.
• If YES is selected, no change to operator calibration is made. If
NO is selected — the POD will change the operator's down direction.
5) Press the SET/CLEAR SET
CLEAR
6) Press CAL/RUN CAL to return to run mode or, press SCROLL
RUN
another function.
GCL-GCX
Counter Door Operator
to enter calibration mode.
CAL
RUN
key. (Pressing the Scroll key at this point will exit
CLOSE
key.
www.geniecompany.com
Figure 2
Figure 3
to shift to
SCROLL
Figure 4
Figure 5
SCROLL KEY
OPEN
SET CLOSE DIR
CLOSE
STOP
CAL SET
SCROLL
RUN CLEAR
OPEN
HIT CLOSE KEY
CLOSE
STOP
CAL SET
OPEN
DID DOOR CLOSE?
CLOSE
STOP
CAL SET
OPEN
YES NO
CLOSE
STOP
CAL SET
SCROLL
RUN CLEAR
SCROLL
08-12
6.2