Open & Close Modes - Genie GCL-MT Manual

Setting Open and Close Modes
Before momentary contact control can be used on the CLOSE button, a monitored external reversing
device such as a photocell system or sensing edge switch must be used.
See WIRING SECTION for installation of entrapment protection devices.
Avant d'utiliser la commande à contact momentané sur le bouton FERMETURE, un dispositif d'inversion
externe surveillée tel qu'un système de cellule photoélectrique ou un commutateur de détection de bord
doit être utilisé.
Voir la section CÂBLAGE pour l'installation des dispositifs de protection contre les piégeages.
OPEN
1. If operator is in RUN mode, press CAL/RUN to enter calibration mode.
2. Press SCROLL (up or down) until display reads "OPEN MODE>MOM" or "OPEN MODE>C-STP. " Fig. 12
• MOM=momentary contact, meaning you press and release the OPEN key and the door will continue to
move until it reaches its travel limit.
• C-STP=constant contact-stop, meaning if you release the key prior to the door reaching its travel limit, the
door will stop.
3. Press SET/CLEAR key to toggle between "OPEN MODE>C-STP" or
"OPEN MODE>MOM" on the display.
4. Press CAL/RUN to return to run mode.
CLOSE
1. If operator is in RUN mode, press CAL/RUN to enter calibration
mode.
2. Press SCROLL (up or down) until display reads "CLOSE
MODE>MOM, " "CLOSE MODE>C-STP" or "CLOSE MODE>C-REV. "
• MOM=momentary contact, meaning you press and release the
CLOSE key and the door will continue to move until it reaches its
travel limit.
• C-STP=constant contact-stop, meaning if you release the key prior to the door reaching its travel limit, the
door will stop.
• C-REV=constant contact-reverse, meaning if you release the key prior to the door reaching its travel limit,
the door will reverse direction.
3. Press SET/CLEAR key to toggle between "CLOSE MODE>C-STP" or "CLOSE MODE>C-REV" or "CLOSE
MODE>MOM" on the display.
4. Press CAL/RUN to return to run mode.
Sec-4.9
Section 4: Programming
WARNING
!
AVERTISSEMENT
!
(Constant vs. Momentary Contact)
OPEN MODE MOM
CAL SET
SCROLL
RUN CLEAR
SCROLL
Fig. 12
OPEN
CLOSE
STOP