Setting Limit Overrun - Genie GCL-J&H Installation Manual

Setting Limit Overrun

AL
U
This Setting is a matter of trial and Error
1) If operator is in RUN mode, press CAL/RUN
calibration mode.
2) Press SCROLL key until display reads "LIMIT OVERRUN>#" where # is
SCROLL
the increment of travel beyond the CLOSE Limit ranging from 0 to 9. Zero
turns off the Overrun function and the door stops at the DOWN Limit.
CLEAR
Nine is the maximum distance the door will travel past the limit. This
function is used to insure a good seal at the bottom of the door.
Figure 9.
SET
3) Press SET/CLEAR key to toggle between 0 and 9—one digit at a time.
CLEAR
4) Pick a value and operate the door. Adjust as necessary.
5) Press a SCROLL SCROLL key to shift to a new function and lock in the setting.
CAL
6) Press CAL/RUN key to return to run mode.
RUN
GCL-J&H
Standard Duty Operator
key to enter
CAL
RUN
CL E
NOTE: The actual distance that the Overrun function covers is variable depending
on model of operator and size of the door (nominally about 2 inches of travel).
WARNING:
reversing devices, including photocells and sensing or reversing edges.
Therefore, any externally connected devices will be disabled during that
portion of door travel which is controlled by the Limit Overrun function.
Figure 9
www.geniecompany.com
The Limit Overrun function will override external
LIMIT OVERRUN #
CAL SET
SCROLL
RUN CLEAR
SCROLL
0 -12
OPEN
CLOSE
STOP
6.5