Advertisement
Quick Links
Automatic
Chain Drive/Belt Drive
Garage Door Operator
System
Complete with
and SERIES II Electronics
Operator MUST be installed with the included SERIES II Wall Control!
Self-diagnostic Electronic Sensory Protection System
(SAFE-T-BEAM SYSTEM) MUST Be Installed To Close Door!
Owner' s Manual
SAVE FOR FUTURE REFERENCE
Customer Service
C A L L : 1 - 8 0 0 - 3 5 4 - 3 6 4 3
V I S I T : W W W . G E N I E C O M P A N Y . c o m
AUTOMATIC GARAGE DOOR OPERATOR SYSTEMS
HANG MANUAL NEAR YOUR WALL CONTROL
Remote Control
GPS-IC Series
PMX-IC B Series
Advertisement
Need help?
Do you have a question about the Pro Stealth and is the answer not in the manual?
Questions and answers
Garage door opens every time with remotes. When closing it turns on the light and makes a clicking sound. Then if you pull the cord and release the door and push close again the starts and reattaches the door and closes. It seems you have to release the pressure on the door in order for the opener to close..
A possible cause of the Genie Stealth garage door opener making a clicking sound and requiring pressure to be released on the door to close is that the safety reverse system is activating. The manual states that the operator must reverse when the door contacts a 1-1/2 inch high object, indicating the presence of an obstruction or excessive resistance. This could happen if the door is binding, not balanced properly, or if there is an issue with the sensors or track alignment.
This answer is automatically generated
Remote Control Opens the Opener, but will not close? Keypad close button has to be held down until the door is completely closed?