Operator Type - Genie GCL-J&H Installation Manual

Operator Type Fig. 3
NOTE: The GDO type is factory set. The installer should not have to set this
feature. However, if the GDO type is inadvertently changed, or if a board needs
to be replaced in the field, follow these instructions to set GDO type.
1) Press CAL/RUN CAL key to enter calibration mode.
RUN
key until display reads "GDO TYPE > ."
2) Press SCROLL
SCROLL
This will display the current GDO type.
3) Press SET/CLEAR key until display indicates correct GDO type
SET
CLEAR
( J-SHAFT or TROLLEY)
4) Press CAL/RUN CAL key to return to run mode.
RUN
GCL-J&H
Standard Duty Operator
Figure 3.
www.geniecompany.com
OPEN
GDO TYPE J-SHAFT
CLOSE
STOP
CAL SET
SCROLL
RUN CLEAR
SCROLL
Figure 3
0 -12
7.2