Power Switch - NEC Express5800/120Rh-2 N8100-1061F User Manual

POWER Switch

Use the POWER switch to turn on/off the server.
Power On
Press the POWER switch on the front of the computer chassis.
The POWER LED lights in green.
IMPORTANT:
If the power cord is connected to a power control device such as a
UPS (Uninterruptive Power Supply), make sure that the power
control device is powered.
The server management logic on your system board monitors and
logs system voltage changes. When plugging the power cord to
the system, you may experience 10 seconds delay from the time you
press the POWER switch on the front panel. This is normal
system operation and is required by the server management logic.
Always allow POST to complete before powering down your
system.
POWER LED
General Description 2-31
POWER
switch