NEC Express5800/120Rh-2 N8100-1061F User Manual page 372

E-10 Installing Windows Server 2003
7.
When the following message is displayed, press S.
Setup could not determine the type of one or more mass storage devices
installed in your system, or you have chosen to manually specify an adapter.
Currently, Setup will load support for the following mass storage devices.
The following message is displayed.
8.
Insert the Windows Server 2003 OEM-DISK for NEC EXPRESSBUILDER into the
floppy disk drive, and press Enter.
A list of mass storage devices is displayed.
Select the [Adaptec Ultra320 SCSI Cards (Win XP/Server 2003 IA-32)] and press Enter.
Then, it returns to the screen of Procedure 7.
9.
If the optional board is installed, select the proper SCSI Adapter and press Enter.
– Adaptec HostRAID U320 Driver Ver 1.02 For Windows 2000/XP/2003
(When Adaptec HostRAID (SCSI) is installed.)
– MegaRAID SCSI 320-1 RAID Controller Driver
(When N8103-80F board is installed.)
– MegaRAID SCSI 320-2 RAID Controller Driver
(When N8103-81F board is installed.)
– Adaptec I2O RAID Driver Disk for 32bit Windows 2000/XP/2003
(When N8103-86 board is installed.)
– LSI Logic MegaRAID SAS RAID Controller Driver (Server 2003 32-bit)
(When N8103-91F board is installed.)
Continue performing tasks according to the subsequent messages that appear.
10.
When the following message is shown, press Enter to start "Welcome to Setup".
11.
When the installation of Windows Server 2003 has finished, the system reboots
automatically.
– Windows Server 2003 has been installed: Go on the step 15.
– Windows Server 2003 R2 has been installed: Go on the step 12.
Please insert the disk labeled
manufacturer-supplied hardware support disk
into Drive A:
*Press ENTER when ready.